Troubleshooting HAA Configuration for a Pool Controller - Sonoff 4ch #2071
MarcinRawski
started this conversation in
MEPLHAA Scripts
Replies: 4 comments 1 reply
-
put your live wire onto your normally opens put your pump and heater on their respective commons and link the heaters common to the pumps normally closed |
Beta Was this translation helpful? Give feedback.
0 replies
-
|
Beta Was this translation helpful? Give feedback.
1 reply
-
@MarcinRawski |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I am attempting to use HAA to configure a custom pool controller setup using an sonoff 4ch pro device. The device is meant to control four different relays corresponding to various pool functions.
The GPIOs are configured as follows:
GPIO 15 garden lamp.
GPIO 12 pool pump.
GPIO 4 pool lamp.
GPIO 5 - electric heater.
GPIO 2 - DS18B20
GPIO14 - water flow sensor (pressure switch)
heater must always start the pump .
All individual functions are working correctly, except I'm unable to link the relay connected to GPIO5 with the relay connected to GPIO12. I would like the relay connected to GPIO5 to switch on whenever the relay connected to GPIO12 is activated.
Here is the HAA JSON configuration I'm using:
Despite my efforts, I haven't been successful in establishing this link between the two relays. Can anyone guide me on how to correctly configure this in the JSON setup? Has anyone encountered a similar issue or have any insights on how to resolve this?
Thank you in advance for your assistance.
Beta Was this translation helpful? Give feedback.
All reactions